Penetrating Sealer 102 Colour Enhancer

Water based, high level stain protecting penetrating sealer for unpolished marble, concrete, pressed pavers, terracotta tiles and a comprehensive range of natural stone.

Sealer 102 is primarily a water based sealer, particularly for application to damp (not wet) surfaces eg. pool surrounds, patios, walls and floors and other large area projects. For more dense surfaces eg. granite or bluestone see Sealer 103 or 104.

Sealer 102 is a natural look sealer. It sits below the surface without effecting slip resistance. It provides maximum stain protection against oils, foodstuffs and airborne pollutants; and can be applied to a wide range of surfaces.

Available in 5 & 20 Litre containers.

Directions for use

A two coat application, wet on wet, will give sufficient protection provided application guidelines are met.

Power wash surfaces to be treated.

Remove stains caused by oil, grease and soils with the recommended Miteq cleaner.

Surface may be damp, but excess water must be removed from the surface prior to application.

Apply using a brush, roller or low pressure spray. Do not apply excessively or allow the sealer to pool on the surface.

Always test a small area prior to commencement to ascertain the effect of the sealer on the surface.

Do not use above 30°C or below 10°C or if rain is imminent.

Use material directly from container. Do not dilute.

The sealed surface will be suitable for foot traffic after 24 hours.

Do not wash down for 48 hours following application.

Coverage will depend on surface porosity. 2m2/litre on very porous surfaces and 5m2/litre on dense surfaces as a guide.

Shelf Life – 12 months in unopened containers.

Read all warnings.

We can be found at:

U1, 45-49 Popes Rd.
Keysborough, Victoria 3173

P: +61 3 9532 5747
F: +61 3 9798 5571

M: +61 438 315 138

sales –
[email protected]

accounts –
[email protected]

manufacturing –
[email protected]

Search