TRADE+ is a natural look sealer for interior and exterior use. A two coat application, wet on wet, will give sufficient protection provided application guidelines are met. The application of TRADE+ will not affect the slip resistance of the surface.
Solvent based natural look, protective penetrating sealer for granite, marble, natural stone, concrete, pressed pavers, and reconstituted stone
Directions for Use
Power wash surfaces to be treated.
Remove oil, grease, and soil stains with the recommended Miteq cleaner.
Ensure surface is completely dry prior to sealing.
Use material directly from can.
Do not dilute.
Always test a small area prior to commencement to ascertain the effect of the sealer on the surface.
Apply to the prepared surface by brush, solvent resistant roller, or low pressure spray.
Apply evenly, do not allow sealer to pool.
Do not use above 30° C or below 10° C or if rain is imminent.
TRADE+ can be re-applied at any time following initial application providing the surface has been suitable cleaned and loose material has been removed.
The sealed surface will be suitable for use after 24 hours. Coverage will depend on surface porosity but as a guide 10-15sqm/ litre as a two-coat application.
Exposure to water may cause material to cure in the container.